Disney Castle Wall
I am thrilled with how my Disney castle wall turned out! I purchased the Cricut file of the castle off of Etsy. The fireworks and Tinkerbell were separate Cricut purchases. In the past, I was never able to get vinyl to work on my walls because they are not flat. This time I used Oracal 631 removable vinyl instead of the Cricut brand (which is too thick) and it worked wonderfully! It does take a bit of time and arm muscles – once adhered to the wall, I used a washcloth (just using your hands will make them sore) to rub the vinyl, pressing into all the grooves on my not-smooth wall. It has stayed up for quite some time with no issues! I purchased a package of cheap frames from Hobby Lobby. I didn’t want to spend a lot because I wasn’t sure if the project would even work. The frames are attached to the wall with command strips (I use these for almost everything!) I hope you enjoy!
What size frames are these? Where did you get designs? I’m very interested in doing this to my house!
The frames are 4×6, 5×7, and the one 8×10. I just bought cheap ones at Hobby Lobby and added them to the wall with Command strips. I bought the design off Etsy, however it doesn’t show in my purchases and I cannot find this exact one so maybe it isn’t there anymore. The castle and the fireworks were 2 separate purchaes (proably from different people). I’m pretty sure the Tinkerbell was from a Cricut cartridge that I already had. Since my walls are not completely flat, I used the Oracal 631 removable vinyl off Amazon. It’s softer and can flex/rub into the dips and valleys, giving it a painted-on look. Good luck with your project! I am continuing to enjoy mine.